Casimersen

Patients with Renal Impairment Renal clearance of casimersen is decreased in non-DMD adults with renal impairment based on estimated glomerular filtration rate (calculated using the Modification of Diet and Renal Disease (MDRD) equation) [see Clinical Pharmacology] . However, because of the effect of reduced skeletal muscle mass on creatinine measurements in DMD patients, no specific dosage adjustment can be recommended for DMD patients with renal impairment based on estimated glomerular filtration rate.

Patients with known renal function impairment should be closely monitored during treatment with AMONDYS 45.

Preparation Instructions AMONDYS 45 is supplied in single-dose vials as a preservative-free concentrated solution that requires dilution prior to administration. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

Use aseptic technique. Calculate the total dose of AMONDYS 45 to be administered based on the patient's weight and the recommended dose of 30 milligrams per kilogram. Determine the volume of AMONDYS 45 needed and the correct number of vials to supply the full calculated dose. Allow the vials to warm to room temperature.

Mix the contents of each vial by gently inverting 2 or 3 times. Do not shake. Visually inspect each vial of AMONDYS 45. The solution is a clear to slightly opalescent, colorless liquid, and may contain trace amounts of small, white to off-white amorphous particles. Do not use if the solution in the vials is cloudy, discolored or contains extraneous particulate matter other than trace amounts of small, white to off-white amorphous particles.

With a syringe fitted with a 21-gauge or smaller bore non-coring needle, withdraw the calculated volume of AMONDYS 45 from the appropriate number of vials. To avoid dulling the needle and fragmenting the stoppers, replace the needle periodically during preparation. Dilute the withdrawn AMONDYS 45 in 0.9% Sodium Chloride Injection, USP, to make a total volume of 100 to 150 mL.

Gently invert 2 to 3 times to mix. Do not shake. Visually inspect the diluted solution. Do not use if the solution is cloudy, discolored or contains extraneous particulate matter other than trace amounts of small, white to off-white amorphous particles. Administer the diluted solution via an in-line 0.2 micron filter. AMONDYS 45 contains no preservatives and should be administered immediately after dilution.

Complete infusion of diluted AMONDYS 45 within 4 hours of dilution. If immediate use is not possible the diluted product may be stored for up to 24 hours at 2 °C to 8 °C (36 °F to 46 °F). Do not freeze. Discard unused AMONDYS 45.

Administration Instructions Application of a topical anesthetic cream to the infusion site prior to administration of AMONDYS 45 may be considered. AMONDYS 45 is administered via intravenous infusion. Flush the intravenous access line with 0.9% Sodium Chloride Injection, USP, prior to and after infusion. Infuse the diluted AMONDYS 45 over 35 to 60 minutes via an in-line 0.2 micron filter.

Do not mix other medication with AMONDYS 45 or infuse other medications concomitantly via the same intravenous access with AMONDYS 45. If a hypersensitivity reaction occurs, consider slowing the infusion, interrupting or discontinuing the AMONDYS 45 therapy [see Contraindications, Warning and Precautions and Adverse Reactions] .